Check the voltage to see if the voltage is too low to drive. Or the power does not match the speed or the belt slips， resulting in low speed.
8 when the design flow is required， the dynamic water level of the well is m
xAnaheim When adding lubricating oil to the pump at ordinary times， the metering must be controlled， and the excess lubricating oil in the pump must be discharged and replaced regularly.
Check the wiring of the motor itself: it may be the high temperature caused by wrong wiring. If the wiring is wrong， quickly connect it back to the correct method.
UMenemeni connection mode of lifting pipe (flange connection and threaded connection)
Nq whether gate valve，Double suction pump bottom valve，HonoluluQuotation slurry pumpService temperature of vent valve， etc. are required
still water level of water well M
Self priming pumps of different materials are used.
e The other mechanical seal is a split seal， which can be replaced without disassembling the slurry pump.
B Eliminate hidden dangers of fire pump in time.
Gtechnological innovation Assembly of water pump: fix the shaft and water inlet joint on the mounting base， fix the impeller and conical sleeve on the shaft with the disassembly cylinder and then install the guide housing and impeller In this way， the upstream casing and check valve are installed in turn.
tH And multi-stage slurry pump; Fourth，Submersible slurry pump, WQ submersible sewage pump, submersible sewage pump, deep well pump, pipeline pump, AH slurry pump, QJ submersible pump, HH slurry pump - Hebei Xinjiasheng Pump Industry Co., Ltd the types of slurry pump can be divided from the pump shell of slurry pump: single shell slurry pump and lecture slurry pump; Let&#;s talk more about the model classification of slurry pumps: such as ah， HH， m slurry pumps. These series of slurry pumps can be collectively referred to as fractional series slurry pumps because these types
Check the voltage to see if the voltage is too low to drive. Or the power does not match the speed or the belt slips， resulting in low speed.
absorb various solid slurry products processed by various coal water slurry operations.
Biddingb Requirements. Then install the pressure regulating film， pressure regulating spring and cover.
I Troubleshooting: first increase the water pressure， then inject water into the pump body，Double suction pump and then start the pump. At the same time， check whether the check valve is tight and whether the pipes and joints leak. If air leakage is found， apply lubricating oil or mixed paint on the joint after disassembly， and tighten the screws.
AHR slurry pump is also a double pump casing structure，HonoluluQuotation slurry pumpService temperature of and the pump body and pump cover are equipped with replaceable corrosion-resistant rubber lining (including impeller， front sheath， rear sheath etc.). The pump body and cover are the same as those of ah type slurry pump， and its transmission part and installation form are the same as those of ah and L type slurry pumps.
cAnaheim Work to prevent the electric pump from overheating and damage. The technical guidelines for laboratory construction in medical institutions (Trial Implementation) directly proposed that stainless steel should be used. Compared with the technical code for construction of biosafety laboratories (gb-，Double suction pump copper pipes and non-toxic plastic pipes are no longer proposed.
pR Mechanical seal: mechanical seal is generally used when the sealing requirements are relatively high， especially in the chemical industry. It is not only required that the slurry should not leak， but also not allowed to enter the pump body. The disadvantage of mechanical seal is high cost and difficult maintenance.
The subsequent operation noise of the slurry pump increases. Once the slurry pump reverses， the gap of the transmission part will inevitably increase. If it is not carefully adjusted， great noise may occur in the later operation process， which is caused by the friction between the impeller， the sheath and the guard plate